Navigation
Sidebar
private:writeups:hamradio
This is an old revision of the document!
Table of Contents
Digital modes
WSPR
Instructions
- Turn on radio
- Plug audio (in/out) from radio into computer
- Run WSJT-X
- Set mode to WSPR
- Set band on WSJT-X and then adjust the radio to the specified frequency.
- Click “upload spots”
- Select correct audio input and output devices under settings/preferences
- In OS, adjust mic gain until input signal is in the green (presumably, unsaturated).
- Watch for several cycles to insure that you are receiving signals. If not, check cables and also the selected audio input devices.
- When ready, turn on enable transmit.
- Use the WSPR map to see where your signals are coming from and going to.
FT8
WSJT-X
JT65
WSJT-X
PSK31
JT9 ????
Olivia ????
private/writeups/hamradio.1595291947.txt.gz · Last modified: 2020/07/21 00:39 by admin
