Instructions

1. Turn on radio
2. Plug audio (in/out) from radio into computer
3. Run WSJT-X
4. Set mode to WSPR
5. Set band on WSJT-X and then adjust the radio to the specified frequency.
6. Click “upload spots”
7. Select correct audio input and output devices under settings/preferences
8. In OS, adjust mic gain until input signal is in the green (presumably, unsaturated).
9. Watch for several cycles to insure that you are receiving signals. If not, check cables and also the selected audio input devices.
10. When ready, turn on enable transmit.