Table of Contents

Digital modes

JS8

software : JS8Call
20 m band : 14.078
bandwidth : 50 Hz
duration : 15 seconds cycle
details : https://www.sigidwiki.com/wiki/JS8

WSPR

software : WSJT-X
20 m band : 14.0956 +
bandwidth : 6 Hz
duration : 120 seconds cycle (115 second duration)
details : https://www.sigidwiki.com/wiki/WSPR

Instructions

  1. Turn on radio
  2. Plug audio (in/out) from radio into computer
  3. Run WSJT-X
  4. Set mode to WSPR
  5. Set band on WSJT-X and then adjust the radio to the specified frequency.
  6. Click “upload spots”
  7. Select correct audio input and output devices under settings/preferences
  8. In OS, adjust mic gain until input signal is in the green (presumably, unsaturated).
  9. Watch for several cycles to insure that you are receiving signals. If not, check cables and also the selected audio input devices.
  10. When ready, turn on enable transmit.
  11. Use the WSPR map to see where your signals are coming from and going to.
  12. Alternative map http://wspr.aprsinfo.com/

FT8

software : WSJT-X
20 m band : 14.074 +
bandwidth : 50 Hz
duration : 15 second cycles (13 duration)
details : https://www.sigidwiki.com/wiki/FT8

JT65

software : WSJT-X
20 m band : 14.076 +
bandwidth : 180 Hz (standard mode)
details : https://www.sigidwiki.com/wiki/JT65

PSK31

software : FLDIGI 20 m band : 14.070 + bandwidth : 63 Hz (standard) details : https://www.sigidwiki.com/wiki/Phase_Shift_Keying_(PSK)

https://www.sigidwiki.com/wiki/Phase_Shift_Keying_(PSK)

FLDIGI

https://pskreporter.info/pskmap.html

bands - https://en.wikipedia.org/wiki/PSK31#Common_frequencies

JT9 ????

Olivia ????

FLDIGI

RTTY

https://www.sigidwiki.com/wiki/Radio_Teletype_(RTTY)